Notes on
1: When using the glass CO2 laser tube,on the water first, the of low in and high out, the of the pipe, that the water is full of the pipe, there is no in the pipe, and then turn on the power . The laser tube be under the of the water , and the water will cause the laser tube to burst. : soft water ( water or water) be used as water, and the water be at 5-35 , not too high or too low. in , once the water is too high, the water be in time or shut down for a of time; the water in cold areas not be , after the laser is shut down Stay in the laser tube to avoid due to of water. ( : for users using , the water tank must be );
2: The two of the laser tube be at the point of 1 / 4 of the total of the laser tube to that the water flow rate is 2l-4l / min; , if the is not good, it will cause mode ,and the light spot will, in power ; the water port in the water tank must be by water, the water in the laser tube will not be fully every time the is off
3: Pay to the of the laser to avoid the smog on the of the ( the of the path), and avoid the of the , and the power will drop. At this time, the of the can be with or silk clothes in ;
4. If it is found that there is no water, the laser tube has been for a of time, but ,the laser tube has not burst, so it must not be with water . It be and , and then water can be when the of laser tube drops. Or it will burst at once
5: The high power of laser needs.
6: pay to: avoid dust near the high- , to , and keep the high- end away from the metal as far as to high- and .
7: The of water (0-40 ℃) be . If the water is too high, the laser life will be . If the water is too high, it be in time
8. To a life of the laser tube, try to for 5 hours and shut down for half an hour.
9. of laser tube can save laser . The best power of laser tube is less than 80% of its own power.
10. Laser tubes with not the to the .
For more about laser tube and laser tube of Laser Co., Ltd., .
